Olympus LS-11 - Manual (Page 18)

1
Ge
ttin
g S
tar
te
d
1
2 3 button
` /OK button
When [MemorySelect] is
set to [SD Card], [Built-in
Memory selected ] will
appear
LOCK
Close the card cover securely.
Note
• Releasing your finger quickly after pushing the
card inward may cause it to eject forcefully out
of the slot.
Ejecting a Card
1
While the recorder is during stop mode,
open the card cover.
• The card is visibly out of the slot and can
be removed safely.
Notes
• It is possible to switch the recording media over
to the built-in flash memory (☞ P.41, P.46).
• In some cases cards which have been format-
ted (initialized) by another device, such as a
computer, cannot be recognized. Be sure to
format them with this recorder before using (☞
P.51).
• When attempting to perform operations such as
rewriting the contents of an SD Card in cases
where the card has been write protected, [SD
Card Locked ] will appear. The playback opera-
tion can be performed, but the write protection
must first be turned off when overwriting the
contents on the card.
• Cards that are not to SD standards, such as
multimedia cards, may not be used.
Push the card inward to unlock it, and
let it eject partially.
When the SD Card is write protected, there will
be a display reading [SD Card Locked]. Before
inserting the card, turn off the write protection
function. Check the Olympus website regard-
ing SD cards which are confirmed operation
with this recorder (☞ P.80).
If the write protection
switch is facing the
[LOCK] direction,
recording and other
functions cannot be
carried out
About the SD Card
Notes
• The recorder may not recognize correctly
on some SD cards. In this case, remove
the card then put it again to see if the
recorder recognizes the card.
• The processing performance reduces in
a SD card when you repeat writing and
delete. In this case, format the SD card
(☞ P.51).).
Inserting and Ejecting a Card