Regency IG35-ULPG - Manual (Page 26)

26 Regency IG35 Gas Inbuilt Fireplace
MAINTENANCE
FAN MAINTENANCE
To Remove Fan:
1) Turn the unit off and allow it to cool to room temperature,
2) Unplug or disconnect power source to stove.
3) Open the bottom louvre.
4) Remove the ECS harness from the back clip.
5) Remove the 2 screws that secure the fan in place.
6) Pull out the ECS box.
NOTE: The ECS box is held in place with velcro.
7) Carefully slide the fan to the front, rotate it 45 degrees and slide it out
simultaneously with the ECS box.
8) Disconnect all the connectors from the fan and resistor.
9) Remove the fan ground cable.
10) Pull out the fan tray.
11) Remove the 3 screws from the back of the fan tray to remove the
fan.
12) Reverse the above steps to install the new fan.
Back Clip
Fan Ground
Cable
Fan
Connectors
Resistor Con-
nectors