Regency IG35-ULPG - Manual (Page 21)

21 Regency IG35 Gas Inbuilt Fireplace
REMOTE CONTROL
Use the Regency Remote Control Kit approved
for this unit. Use of other systems may void
your warranty.
The remote control kit comes with a hand held
transmitter and a wall mounting plate.
1) Choose a convenient location to mount
the hand held transmitter, protection from
extreme heat is very important.
By usiing the wall mounting plate to house the
transmitter, the remote can also be used as a
wall thermostat.
FINAL CHECK
Before leaving this unit with the customer, the
installer must ensure that the appliance is fi ring
correctly. This includes:
1) Clocking the appliance to ensure the cor-
rect fi ring rate (rate noted on label) at 15
minutes.
2) If required, adjusting the primary air to
ensure that the fl ame does not carbon.
First allow the unit to burn for 15 min. to
stabilize.
3) Check for proper draft.
CAUTION
Any alteration to the product that
causes sooting or carboning that
results in damage to the exterior
facia is not the responsibility of the
WIRING
Caution: Ensure that the wires do not
touch any hot surfaces and are away
from sharp edges.
STANDARD WIRING
This unit is polarity sensitive and will
not operate if polarity is incorrect.
INSTALLATION