Regency IG35-ULPG - Manual (Page 13)

13 Regency IG35 Gas Inbuilt Fireplace
The "02" refer numbers (i.e. 02-65) are
molded into the rear of each log.
1) Carefully remove the logs from the box and
unwrap them. The logs are fragile, handle
with care - do not force into position.
2) Sprinkle the embers on the front, left and
right sides of the fi rebox base.
LOG SET
INSTALLATION
Read the instructions below carefully and
refer to the diagrams. If logs are broken
do not use the unit until they are replaced.
Log kit #730-935 contains the following:
a) 02-65 Rear Log
b) 02-56 Middle Left Log
c) 02-44 Front Left Log
d) 02-46 Left Top Log
e) 02-45 Front Right Log
f) 02-47 Center
Log
g) 02-48 Middle Right Log
h) Embers
902-151
i) Lava 902-154
A)02-65
3) Place Rear Log A)02-65 on the two pins on
the rear log support.
4) Place the Middle Left Log B)02-56 on the
two pins from the rear left side.
6) Place Front Left Log C)02-44 onto the 2
front pins as shown.
Embers Embers
B)02-56
5) Place lava rock in front of middle left log as
shown in the picture.
C)02-44
D)02-46
B)02-56
A)02-65
7) Place the Left Top Log D)02-46 on the pin
on Log B)02-56 and on top of the cutout
on Log A)02-65.
C)02-44
8) Place Front Right Log E)02-45 on the two
pins as shown.
9) Place the lava rock in the area between
the left and right logs, leaving a space in
the middle for log (F) 02-47.
Ensure that the lava rocks are not placed
directly over the burner ports.
E)02-45
Lava Rock
Log kit #486-930 contains the following:
a) 02-50 Side Log
b) 02-52 Side Log
c) Embers
902-151
d) Lava 902-154
Installation of Kit 730-935:
INSTALLATION