Ricoh Aficio 3235C EN - Manual (Page 111)

Form Feed
105
4
Form Feed
This section gives instructions for op-
erating the machine when there is no
tray for the selected paper size or
type, or when paper loaded in the
machine has run out.
Limitation
❒ The tray cannot be changed if the
following functions are set for it:
• Staple
• Punch
• Duplex Printing to a tray that
does not support duplex print-
ing
• Cover Sheet
• Front and Back Covers
• Slip Sheet
Note
❒ If form feed is selected for a tray
with the following settings, you
can change the tray by canceling
the settings:
• Staple
• Punch
❒ If Auto Continue is selected, form
fed paper is printed after a set in-
terval. See p.115 “System”.
If the machine does not have a tray for
the selected paper size or paper type,
or if the selected paper loaded in the
machine has run out, a caution mes-
sage appears.
If this message appears, do one of the
following:
Print Using a Selected Tray
AAAA
Select the tray for form feed from
those that appear on the display
panel.
If you want to print after adding
paper to the tray, select the tray af-
ter loading the correct paper.
Note
❒ To load paper in the bypass
tray, see p.14 “Setting Paper on
the Bypass Tray”.
BBBB
Press [Continue].
The machine prints using the se-
lected tray.
Note
❒ If a tray with a smaller paper
size is selected, the print job
may be cut short, or other prob-
lems may occur.
JupiterC2EN-Print-F2_FM.book Page 105 Friday, December 17, 2004 8:17 PM