Ricoh RDC-5000 - Manual (Page 97)

95
Playback/Erasing
4
Erase
The selected file is erased.
Important
Note
• Remember that files cannot be restored once they are erased. Before
starting to erase a file, make sure that you want to erase it.
q
Set the mode dial to [ ] and press the
CARD/IN button to select a source file to
be erased.
An erase menu is displayed.
w
Press the or button to select
[ERASE SINGLE IMAGE] and press the
ENTER button.
The erase single image menu is displayed.
Note • To cancel the operation, set the mode
dial to another mode.
e
Press the or button to select an
image file to erase.
Note
• To cancel the operation, press the
MENU button. The erase menu is
displayed.
r
Press the shutter release button.
The image file thus selected is erased. If you
want to erase more files, repeat steps
e
and
r
above.
t
Press the MENU button to end the
ERASE SINGLE IMAGE operation.
The erase menu is displayed again. Then, turn
the mode dial to select another mode.
Note • When a lower numbered file is erased, the higher numbers are reassigned.
• Erasing may take longer with some types of SmartMedia memory cards
and files.
• Protected files, which are identified by the mark, cannot be erased
until they are unprotected. See “Protecting a File” (p.87).
E R A S E 5 / 1 2
S I N G L E I M A G E
S T A R T : R E L E A S E
C A N C E L : M E N U
E R A S E 5 / 1 2
S I N G L E I M A G E
S T A R T : R E L E A S E
C A N C E L : M E N U
M E N U [ E R A S E ]
E R A S E S I N G L E I M A G E
E R A S E A L L I M A G E S
E R A S E S E L E C T E D I M A G E S
S E L . : E N T E R