Renesas H8/36109 - Manual (Page 18)

5
Section 2 Connection Procedures
WARNING
Always switch OFF the user system and the emulator
product before the EXPANSION I/O BOARD or USER
SYSTEM INTERFACE CABLE is connected to or removed
from any part.
Before connecting, make sure that pin 1 on each side is
correctly aligned. Failure to do so will result in a FIRE
HAZARD and will damage the user system, the emulator
product, the user system interface cable, and the expansion
I/O board, or will result in PERSONAL INJURY. The USER
PROGRAM will be LOST.
2.1 Using Emulator without Connecting User System
1. Make sure the emulator is turned off.
2. After making sure the direction of the expansion I/O board connector (labeled E6000
EMULATOR) is correct, firmly insert the expansion I/O board connector into the emulator
station connector (labeled USER INTERFACE). It is possible to use the expansion I/O board
connecting only to the emulator.