Robertshaw 9620 - Manual (Page 4)

3. Place AUTO-ON switch into AUTO position.
4. Remove the cover using a coin or screwdriver (Figure 2).
FIGURE 2
5. Place thermostat against the wall at desired location. Make sure
wires will feed through opening on base of thermostat.
6. Mark placement of mounting holes (Figure 3). Set base aside.
FIGURE 3
7. Drill the marked holes using a 3/16" drill bit. NOTE: Enclosed plastic
anchors do not require a drilled hole for drywall.
8. Tap plastic anchors into the holes.
9. Align base with plastic anchors and feed wires through opening
(Figure 3).
4
EM
PROG
MAN
Y2
Y
1
E
G W2
FAN AUTO ON COOL OFF HEAT EM
CHANGE SET PROG/MAN
AM
PM
MORN DAY EVE NITE EER
O
B
C L R
MOUNTING HOLES
WIRE OPENING