Robertshaw 9620 - Manual (Page 11)

11
>
>
ET PROG/MAN C
PROG
MAN
PROG
MAN
SET PROG/MAN COOL-OFF-HEAT-EM
AUX CHECK EMER
AUTO - ON >
>
>
>
PROG
MAN
SET PROG/MAN COOL-OFF-HEAT-EM
AUX CHECK EMER
AUTO - ON
> >
PROG
MAN
SET PROG/MAN COOL-OFF-HEAT-EM
AUX CHECK EMER
AUTO - ON
>
>
AUTO - ON
SUMMER
WINTER
COOL-OFF-HEAT-EM
COOL-OFF-HEAT-EM
NOTE: O NCE THE THERMOSTAT TURNS THE SYSTEM OFF WHILE IN THE COOL OR HEAT MODE , A BUILT - IN DELAY KEEPS THE COMPRESSOR FROM TURN -
ING ON FOR ABOUT 5 MINUTES . T HIS PROTECTS THE COMPRESSOR . N O ADDITIONAL TIME DELAY RELAY ( DELAY ON BREAK ) IS NECESSARY . T O OVERRIDE
THE 5- MINUTE DELAY FOR INSTALLATION , PRESS RESET. T HIS WILL ERASE THE DELAY AS WELL AS ALL PROGRAMMING .
◆ Begin Programmed Operation
1. Place AUTO-ON
into AUTO.
2. Place COOL-OFF-HEAT-EM
into COOL or HEAT,
depending on the season.
3. Press PROG/MAN button
until indicator is in PROG position.
◆ Temporary Program Override
To temporarily increase or decrease temperature:
Press or .
The thermostat will automatically return to the program at the next sched-
uled setting change or after four hours.