RuggedCom RUGGEDMAX WIN7000 - Manual (Page 15)

3. Installation Procedures
RuggedCom® RuggedMAX WiN7000 15 Installation Guide Rev1
3. Installation Procedures
3.1. Pre-Installation Safety Instructions
Installing the WiN7000 can pose a serious hazard. Be sure to take precautions to avoid
the following:
• Exposure to high voltage lines during installation
• Falling when working at heights or with ladders
• Injuries from dropping tools
• Contact with AC wiring (power system connection)
3.2. Package Components and Unpacking
Check that the package contains:
• WiN7000 WiMax Base Station.
• GPS antenna
• 2 × RF cables 1.6 m for connection to antenna
• Pole / wall mount kit
• WiNPS 48V power supply for Copper and SFA configuration
3.3. Installation Tools
• Phillips screwdriver
• Wrench or socket set
• Drill and 5/16" drill bit
• Self-fusing electrical tape or insulating putty suitable for use in the unit’s installation environment
• Hammer