Radio Shack 43-3880 - Manual (Page 22)

S
e
tting M
enu O
p
tions
22
Setting the Ring Time
Ring Time allows you to set the number of
rings the caller hears before your answering
system plays the outgoing message. You
can set the ring time to answer after two,
four, or six rings. If you enable the Toll
Saver (TS), the answering system picks up
after two rings if you have new messages
and after four rings if there are none.
1. Press the MENU soft key. Select the
Answ. Setup menu, and then the Ring
Time submenu.
2. Press VOL/RING/ or VOL/RING/ to
select a Ring Time (Toll Saver, 2 Times,
4 Times, or 6 Times).
3. Press the OK soft key. You will hear a
confirmation tone.
Setting the Record Time
Record Time sets the duration for recording
the incoming messages. You have three
record time options. The options “one
minute” or “four minutes” set the duration for
recording the incoming messages.
“Announce only” answers the call but
prevents the caller from leaving a message.
1. Press the MENU soft key. Select the
Answ. Setup menu, and then the
Record Time submenu.
2. Press VOL/RING/ or VOL/RING/ to
select Record Time (1 Minute, 4
Minutes, or Announce Only).
3. Press the OK soft key. You will hear a
confirmation tone.