Connecting an external ir receiver, Figure 3-15 . external ir receiver connection, Connecting to ac power – Runco LIGHTSTYLE LS-HB User Manual
Page 53: Projector, Anamorphic lens transport, 15. external ir receiver connection, Pre l iminar y
Runco LS-HB Installation/Operation Manual
37
PRE
L
IMINAR
Y
Connecting an External IR
Receiver
If infrared signals from the remote control cannot reach the projector due to excessive
distance or obstructions such as walls or cabinet doors, you can connect an external IR
repeater system to the IR INPUT on the LS-HB to extend the range of the remote control.
See Figure 3-15.
Figure 3-15. External IR Receiver Connection
Connecting to AC Power
Projector: The LS-HB ships with various types of AC power cords. Choose the one that
is appropriate to your locale.
Plug the female end of the power cord into the AC receptacle on the rear of the projector
(AC 100V ~ 240V); see Figure 2-3. Then, connect the other end to your AC power source.
Anamorphic Lens Transport: An
AC-to-DC power adapter is provided for
the lens transport. Connect the power
adapter to the +9V DC In jack on the
rear of the lens transport assembly.
Connect the other end to an AC power
source.
ON
l
PO
W
ER
O
FF
1
4
2
3
5
M1
G
A
MMA
PI
P
M2
OS
SW
A
P
M3
SHARP
NR
LI
G
H
T
▲
▼
▲
▼
EN
TE
R
ME
N
U
U
SE
R
ME
MO
R
Y
SO
URCE
(3.5-mm, mini
phono plug)
IR Sensor
IR Repeater
Remote Control