Factory reset – Roberts Radio WM201 User Manual

Page 56

Factory reset

If you wish to completely reset your radio to its initial state this may be

performed by following this procedure.

1. Use the Select control to switch on your radio and to access the

menus. If needed, use the Back option to access the main Mode

menu. Rotate the

Select control until 'Conﬁgure' is highlighted on

the display.

2. Press the Select control to enter the Conﬁgure menu. Rotate the

Select control until 'Factory Reset' is highlighted on the display.

3. Press the Select control again and the display will show 'Are you

sure?'. Rotate the Select control to highlight 'Yes' if you wish to carry

out a system reset or highlight 'No' if wish to return to the previous

screen. Then press the Select control again.

4. A full reset will be performed, the station list together with any preset

stations will be erased and your wireless network connection details

will be lost. All conﬁguration settings will be restored to their defaults,

and the language used for menus will be reset to English.

In the event that you are unable to access the menus (or if the language

setting has accidentally been changed to a language that you cannot

understand) the Factory Reset may also be performed as follows:

1. Remove all power from the unit and wait 30 seconds.

2. Then, re-apply power while simultaneously pressing and holding the

front panel rotary control. Keep this pressed as the radio powers up

and until it displays 'Factory Reset Complete'. This should normally

only take between 10 and 15 few seconds. Then, release the control

while the radio restarts.

3. If this is not successful, please remove power for one minute, and

then repeat the operation.

1-3

Are you sure?

YES NO

Radio Stations

Media Player

Auxiliary input

Alarm clock

Conﬁgure

Off

Version

Upgrade Firmware

Factory Reset

Factory Reset

Complete