Roberts Radio WM201 - Manual (Page 52)

51
Network Configuration
This menu enables you to configure your radio’s network settings, scan for
a connection to an alternative wireless network, or to manually configure
the network parameters. This can be useful if you take the Internet radio
to another location where there is a different network setup.
It is possible to configure your radio to connect to your network via an
available Ethernet connection (RJ-45) or via a Wi-Fi router.
Configuring the radio only to use a wired Ethernet
connection
1. From the radio’s Network Configuration menu, select 'Wired / Wireless'.
This menu will present you with three options: 'Wireless Only',
'Wired Only' and 'Auto'. Selecting 'Wired Only' will allow cause the radio
to restart and then to use only its Ethernet connection to communicate
with the network. The radio will also disable its wireless network
capabilities. This will require your radio to be physically connected to
a wired Ethernet using the RJ-45 socket on the rear panel.
Configuring the radio only to use a Wi-Fi connection
2. Selecting the 'Wireless Only' option from the 'Wired / Wireless' menu
will allow cause the radio to restart and then only to use only its Wi-Fi
connection to communicate with the network. The radio will also disable
its Ethernet connection.
1,2
Radio Stations
Media Player
Auxiliary Input
Alarm Clock
Configure
Off
Aux Input Level
Backlight
Language
Clock Setup
Network
Register
Version
Scan for networks
Enter network name
View Config
Edit Config
Wired/Wireless
Signal Warning
<< Back
Auto
Wired Only
Wireless Only
<< Back