Raypak XPAK 120 - Manual (Page 7)

7
Setting the time
Turn the left-hand knob (SELECT) to
and turn the EDIT knob to set the current time. After
setting the parameter, turn the SELECT knob back to
“RUN.”
Setting the holiday program
Turn the SELECT knob to “MODE,” and then turn the
EDIT knob to “HO” and set the required number of
days holiday. Turn the SELECT knob back to “RUN.”
The function begins immediately and ends at midnight
on the last set day.
“ ”
Fig. 4: Setting the holiday program
(Example shown indicates a 5-day holiday.)
Heating program 2 is be used to modify parameters 1
(Monday) to 7 (Sunday). To set heating program 2,
enter the technical menu and select parameters 1 to 7
depending on the day being set. To do so, turn the
SELECT knob to “MODE” and then select “PL” with
the EDIT knob.
Select the required parameter by turning the SELECT
knob clockwise: 01 for Monday through 07 for Sunday.
Next to the heating program sign, the display shows
the current program in hours, the day or group of days
to which the programming refers, the programming
time and, the first hour block, which will be flashing. On
and off times are then set for both heating programs.
Turn the right-hand (EDIT) knob counter-clockwise to
set the heating phases at setback temperature. Turn
it clockwise to set the heating phases at comfort tem-
perature. Every turn of the knob corresponds to a 15-
minute increase in time, and every movement of the
cursor corresponds to a 1-hour increase.
To exit heating program 1 settings, turn the SELECT
knob to “RUN.”
To exit heating program 2 settings, after programming
the days of the week, turn the SELECT knob clockwise
to “PL,” turn the EDIT knob counter-clockwise until it
reaches the required operating mode (see the dedicat-
ed section). Then turn the SELECT knob to “RUN.”
Programming takes place throughout the 24 hours.
After 23:45, the hour block switches to 0:00.
Fig. 5: Setting the heating program
Setting the heating program
The remote control unit can be used to set two heating
programs.
Heating program 1 is used to modify two blocks of
days independently: Monday-Friday and Saturday-
Sunday.
To set heating program 1, turn the SELECT knob to “6
– 7” in order to modify Saturday and Sunday settings
or to “1 – 5” in order to modify those of the rest of the
week.