Ricoh G1168604A - Manual (Page 47)

Installing Options
47
M
Align the power cable to the left side groove of the duplex unit, and then
slide the duplex unit in until it is connected to the printer.
If the duplex unit is not attached, this step is not necessary.
❒ Be sure to return the provided screwdriver to its original position on the in-
side of the front cover.
❒ After finishing the installation, you can check the memory unit is properly
installed: Print the configuration page from the “List/Test Print” menu. If it
is installed properly, you will see the memory capacity for “Total Memory”.
❒ To expand memory, remove the default SDRAM module, and then install
the SDRAM module (256 MB). “Total Memory” will be the size of SDRAM
module memory unit you installed.
❒ If the memory unit is not properly installed, repeat the procedure from the
start. If you cannot install it properly even after reinstallation, contact your
sales or service representative.
For printing the configuration page, see p.32 “Test Printing” .