Ricoh G1168604A - Manual (Page 39)

Installing Options
39
❒ If you attach two paper feed units at the same time, stack them up in ad-
vance.
D
There are three pins on the top of the paper feed unit that point straight
up. On the bottom of the printer there are three holes. Align the holes
over the pins, and then lower the printer gently onto the paper feed unit.
E
Attach the interface cable to the printer.
F
Plug the printer's power cable back into the wall outlet, and then turn on
the power.
❒ After finishing installation, you can check whether the paper feed unit is
properly installed: Print the configuration page from the “List/Test Print”
menu. If it is installed properly, you will see “Paper Feed Unit (Tray 2)” or
“Paper Feed Unit (Tray 2), Paper Feed Unit (Tray 3)” under the “Options”
list.
❒ If the paper feed unit is not installed properly, repeat the procedure from
the start. If you cannot install it properly even after reinstallation, contact
your sales or service representative.
For printing the configuration page, see p.32 “Test Printing” .