Renesas M3S-UFLA32R - Manual (Page 34)

M3S-UFLA32R
UART Flash Memory Programming Utility
REJ10B0239-0140/Rev.1.40 Mar. 2007 Page 28 of 30
(2) In the "ID code setting" dialog, the ID code for verification is set.
Table 5.17.1 shows function list of operable and not operable functions according with the verify
result.
Choose [Specify ID code by hexadecimal] to set the ID code by hexadecimal.
Choose [Specify ID code by alphanumeric] to set the ID code by alphanumeric characters.
Click [OK] to enable the setting, and then close the "ID code setting" dialog.
Click [Cancel] to disable the setting, and then close the "ID code setting" dialog.
Note: In the 3218x Group and 3219x Group, 12-byte of the address H’84 to H’8F is enabled.
In the other MCU, 16-byte of the address H’84 to H’93 is enabled.
Figure 5.17.2 ID Code Setting Dialog
Table 5.17.1 Operable, Not Operable List
Function
ID code is corresponding or
every ID code in the MCU is FFh
ID code is not corresponding
Load YES YES
Exit YES YES
Lock Bit Information YES NO
Program YES NO
Erase YES NO
Block Erase YES NO
Lock Bit / Set YES NO
Lock Bit / Enable YES NO
Lock Bit / Disable YES NO
Blank Check YES NO
Verify Check YES NO
Batch processing / E.B.P.V. YES NO
Batch processing / E.P. YES NO
Batch processing / B.P.V. YES NO
Setting YES YES
ID Code Setting YES YES
Version information YES YES
Note: YES: Operable, NO: Not operable