Renesas M3S-UFLA32R - Manual (Page 24)

M3S-UFLA32R
UART Flash Memory Programming Utility
REJ10B0239-0140/Rev.1.40 Mar. 2007 Page 18 of 30
(2) In "Lock Bit Set" dialog, the blocks without setting of lock bit are displayed.
Click [Select All] to select all blocks.
Click [Clear] to clear all selected blocks.
Select the blocks you wish to set lock bit to, and then click [OK] to close "Lock Bit Set" dialog.
Subsequently, the dialog that shows execution process appears and the lock bit is set. After
completing setting, the dialog is closed and "Lock Bit Set …finish" dialog is displayed.
Click [Cancel] to close "Lock Bit Set" dialog.
Figure 5.8.2 Lock Bit Set Dialog
(3) Click [OK] in the "Lock Bit Set…finish" dialog to close the dialog.
Figure 5.8.3 Lock Bit Set Finish Dialog