RCA VG4259 - Manual (Page 15)

13
Using the Remote Control
VCR Function Buttons
(continued)
REC (Record)
Starts the VCR recording.
Used for one touch recording.
REW (Rewind)
Rewinds the tape when the VCR is
stopped.
Quickly searches a tape in reverse
motion during playback.
SEARCH
Displays the INDEX, ZERO and BLANK
search menus on the TV screen.
Advances a tape 60 seconds during
playback.
SLOW•F.ADV (Frame Advance)
Used for slow-motion playback.
Advances a tape one frame with each
press of the button when tape is paused
during playback
.
SPEED (Tape Speed)
Selects a recording speed
(
SP or SLP ).
STOP
Stops the VCRÕs normal functions such
as record, playback, rewind, fast
forward, and pause.
TRACKING Up or Down
Reduces the streaks that may appear on
the picture during play, slow, or pause.
Reduces picture ÒjitterÓ during stop-
action playback.
TV•VCR
Switches the picture signal so
that it either comes from the VCR or the
TV channel. See ÒStartupÓ section.
CHAN (Channel) Up or Down
Selects next higher or lower channel in
the TVÕs channel memory when remote
is set to control a TV.
CLEAR
Removes menus or status displays from
the screen.
DISP (DISPLAY)
Shows the status displays on the screen.
Removes menus or displays from the
screen.
POWER
Turns off a compatible TV when remote
is set to control that TV.
Used with the TV button to turn on a
compatible TV that the remote has been
programmed to control. See ÒControlling
a TVÓ section.
MUTE
Turns the TV sound on or off.
Numbers (0 through 9 )
Selects a channel up to 99Ñpress two
numbers.
Selects a cable channel over 99Ñpress
and hold
1 until 1-- appears on the
screen. Then, press the other two
numbers.
PREV CH ( Previous Channel)
Switches between two channels.
Select one channel and then select
another. Press
PREV CH to switch
between the two channels.
Used as an ENTER button on some TVs.
VOL (Volume) + or Ð
Raises and lowers sound.
TV Function Buttons
Press the TV button to set remote to control a compatible TV. Some buttons may not work with the TV.
Cable Box or Satellite Receiver Function Buttons
Press the CABLE button to set remote to control a compatible cable box or satellite receiver. Some buttons may not work with
the cable box or satellite receiver.
Remote Control
CHAN (Channel) Up or Down
Selects next higher or lower channel.
Numbers (0 through 9 )
Selects a channel using the numbers.
POWER
Turns off a compatible cable box or
satellite receiver when remote is set to
control it.
PREV CH ( Previous Channel)
Used as an ENTER button for some
cable boxes and/or satellite receivers.