Procedure – Roland AR-200 User Manual
Page 22
22
Recording Audio
Procedure
Make the correct connections, then turn on the power switch.
1
Insert a formatted card into one of the slots.
2
Press the [
] or [
] button to select the number of the phrase
to be recorded.
The non-recording phrase number in display is flashed.
fig.rec-05
* If you are re-recording over a previously recorded phrase, you should delete the
phrase. (p. 26)
* You cannot change the phrase number after recording, so be sure to select the phrase
number you want to record.
3
Hold down the STOP button and press the PLAY button to go
into recording standby.
The PLAY indicator is flashed while the recording standby mode.
4
Input the sounds from the device connected to the input jacks,
then use the input volume knob to adjust the recording level
so that the MIDI/CLIP indicator does not light.
Nominal Input level:0 dBm
Maximum input level: +2.5 dBu
* If signals louder than +2.5 dBu are being input, rotate the input volume knob to the
left of center.
* Press the STOP button and recording standby mode will end.
AR-200_e.book 22 ページ ２００３年７月１４日 月曜日 午後１時１１分