St2s operation, St2-rc remote control, St2-rc remote control operation – Russound ST2S User Manual

Page 22

ST2S OPERATION

ST2-RC REMOTE CONTROL

ST2-RC Remote Control Operation

The ST2-RC remote control is the only means of
remote operation of the ST2S in a non--RNET system.
The ST2S front panel displays information for the
tuner that is receiving commands from the ST2-RC.
However, the ST2-RC commands do not change
which tuner is playing; that is done through the sys-
tem’s source selection.

Turning the unit on/off

To switch the ST2 tuner in or out of standby mode,

push

or any other button except TUNER 1 or

TUNER 2.

Selecting the desired tuner

To control a tuner, push

. When

pressed, these buttons will be backlit green for Tuner
1 (SIRIUS) and amber for Tuner 2 (AM/FM). Each time
a tuner is selected, the next button press will refresh
the display with the current station or preset for that
tuner,

and all subsequent button presses and memory

preset entries will be associated with that selected
tuner.

Selecting the desired band (AM/FM only)

Push

to switch between AM and FM reception.

Selecting the desired frequency or channel

Use

and

for manual tuning. To move quickly

through the stations or channels, press and hold
either of the Tune buttons for more than 1.5 seconds.

To directly select a station or channel, press

and enter the two- or three-digit SIRIUS channel num-
ber, or the three- or four-digit station frequency
(1071 for 107.1, etc.). European regions use five-
digit station frequencies.

Selecting a mode (SIRIUS)

Push

to select an SIRIUS operating mode.

Exiting a mode (SIRIUS)

Push

to exit the SIRIUS operating mode selection

menu.

Frequency Seek (AM/FM only)

The SEEK function is performed by pressing and

releasing

to seek lower frequencies or

for

higher frequencies. SEEK tuning begins at the current
frequency, seeks upward and stops at the next tuned

station. Pushing

continues the SEEK function.

Once the highest frequency is reached, the tuner con-
tinues in SEEK mode at the lowest frequency.

Selecting Stereo or Mono Output
(AM/FM only)

Press

to toggle between stereo and mono mode.

STEREO or MONO appears briefly on the screen when
selecting mode. Normal operation is in stereo mode.
On a preset, the stereo/mono setting is saved for
that preset.

Selecting Distant or Local Reception
(AM/FM only)

Press

to toggle between Distant and Local

mode. DISTANT or LOCAL appears briefly on the
screen when selecting mode. Normal operation is in
Distant mode.

Recalling a Memory Preset

To recall a memory preset, select the desired tuner,

press

and enter the desired bank number

(1-6), then press

and enter the desired preset

number (1 to 6). The memory presets can also be

accessed by using

and

to scroll through all

presets for the selected bank.

Saving Favorites

The remote control stores two “favorites” (similar to
memory presets) per tuner. These are set simply by
selecting either Tuner 1 or Tuner 2, setting the

desired frequency and pressing and holding

until “FAV1 (2) saved” appears on the tuner.

Stored Favorites are then recalled by pressing either

or .

FAV 2

FAV 1

FAV 2

FAV 1

MEM

BANK

LOC/

ST/

MONO

ST/

MONO

TUNE

AM/FM

TUNER 2

TUNER 1

PWR