Roberts Gorden DAT100 - Manual (Page 52)

www.rg-inc.com Printed in the U.S.A.
Attach this information to the wall near the ROBERTS GORDON ® heater
Installation Code and Annual Inspections: All installations of ROBERTS GORDON ® products must be performed by a contractor qualified in the installation and service of gas-fired heating equipment
and conform to all requirements of all applicable governmental authorities pertaining to the installation and operation of the equipment.
For optimum performance and safety, Roberts-Gordon recommends that a qualified contractor annually inspect your ROBERTS GORDON ® products and
perform service where necessary, using only ROBERTS GORDON ® replacement parts.
© 2005 ROBERTS GORDON ® All rights reserved. No part of this work covered by the copyrights herein may be reproduced or copied in any form or by any means - graphic, electronic, or mechanical,
including photocopying, recording, taping or information storage and retrieval systems - without the written permission of Roberts-Gordon.
Read the installation, Commissioning, Operation and Service Manual thoroughly before installation, operation or service.
OPERATING INSTRUCTIONS
1. STOP! Read all safety instructions on this information sheet.
2. Open the manual gas valve in the heater supply line.
3. Turn on electric power to the heater.
4. Set the thermostat to desired setting (above ambient temperature).
The automatic starting sequence begins.
NOTE: Following long shutdown periods, the burner control may go to
to 'LOCKOUT' during the start sequence. Push the reset button to
recommence firing. Contact service department if 'LOCKOUT'
continues (see manual for details).
1. Turn the thermostat/time switch to 'OFF'. The burner will turn 'OFF'
immediately, but fans will continue to cool heat exchanger until the fan
thermostat switches off.
1. Set the thermostat to off or the lowest setting.
2. Turn off electric power to the heater.
3. Turn off the manual gas valve in the heater supply line.
4. Call your registered installer/contractor qualified in the installation
and service of gas-fired heating equipment.
IF THE HEATER WILL NOT OPERATE, TO ENSURE YOUR SAFETY,
FOLLOW THESE INSTRUCTIONS TO SHUT DOWN YOUR HEATER
Fire Hazard
Some objects can catch fire or explode when placed
close to heater.
Keep all flammable objects, liquids and vapors the
required clearances to combustibles away from heater.
Failure to follow these instructions can result in death,
injury or property damage.
TO TURN OFF THE HEATER
Service Telephone: +44(0) 1902 498733
Service Fax: +44(0) 1902 401464
E-mail: [email protected]
E-mail: [email protected]
WARNING
Roberts-Gordon, LLC
1250 William Street
P.O. Box 44
Buffalo, NY 14240-0044 USA
Roberts-Gordon Europe Limited
Oxford Street
Bilston, West Midlands WV14 7EG UK
Telephone: +44(0) 1902 494425
Fax: +44(0) 1902 403200
®
Clearances to Combustibles
**80 cm is necessary to service heater.
50 cm 50 cm**
30 cm
15 cm
Alternative
Wall
Terminal
Roof Terminal
Air
Intake
Flue
15 cm
2.5 - 3.5 m*
3 m
60 cm
Installation Clearances
Customers
Suitable
Condenser
Unit
Insulated
Refrigerant pipes
to cooling coil
by Customer
Condense Drain
Install to
suitable drain
Air Flow
Telephone: 716.852.4400
Fax: 716.852.0854
Toll Free: 800.828.7450