Roberts Gorden DAT100 - Manual (Page 15)

SECTION 5: H EATER I NSTALLATION
9
SECTION 5: HEATER INSTALLATION
5.1 General
DualAir ® units are designed for installation above 2.5
m. When connected to duct delivery systems any
suitable location will be acceptable.
For floor mounting, the DualAir ® unit may stand
directly on its base.
5.2 Handling
All DualAir ® units have steel channel sections at the
base to be used to support the equipment. Three
steel sections are also provided across the top of the
unit for support. The DualAir
® unit may be
suspended from these top sections.
The DualAir ® unit is heavy and proper handling
equipment must be used by trained engineers.
5.3 Shelf Mounting and Suspension
For typical suspension See Page 9, Figure 3.
Figure 3: Suspension Methods
WARNING
Crush Hazard
Use 12 mm steel drop rod
minimum.
Failure of the supports can
result in death, injury
or property damage.
12 mm
Steel
Drop Rod
Nut
Washers
Nut
Locknut
Rolled Steel
Channel
Floor
Base