Renesas Single-Chip Microcomputer M34551T2-MCU - Manual (Page 16)

( 14 / 40 )
4.2 Specifications
Table 4.1 lists specifications of the M34551T2-MCU.
Table 4.1 M34551T2-MCU Specifications
Port
P2
0
, P2
1
* 2
P1
0
- P1
3
P0
0
- P0
3
D
0
- D
5
M34551MX-XXXFP
M34555MX-XXXFP
M34551E8FP (included)
M34555M4-002FP (mounted)
Direction
Input
Input/output
Devices used
Input: 74HC4066
Input: 74HC541
Output: 74LS06
Output type
-
N-channel
open drain
233 (L) x 135 (W) x 26 (H) mm
5 to 35 ° C (non-condensing)
M34551T2-MCU * 3
100-wire half-pitch cable
50-wire normal-pitch cable
External trigger cable
PCA4029
M34551E8FP (for replacement)
OSC-2 (for changing frequencies) *
4
Power code
Rubber legs (4 pieces)
Applicable MCUs
Evaluation MCUs
Maximum operating
clock frequency
Target system voltage
Power supply
Port emulation
Board dimensions
Operating temperature
Product configuration
*1 Operates in the medium-speed mode (instruction clock: f (X
IN
)/12) immediately after reset
termination.
*2 Ports P2
0
and P2
1
are used with both SEG
16
and SEG
17
, and function as output ports when the
segment output is selected.
*3 "M34551T-MCU" is printed on the board.
*4 The M34551T2-MCU has an oscillator circuit board OSC-2 (for 4.0 MHz) when shipped from
the factory. In addition, it comes with an oscillator circuit board OSC-2, with only a connector
J1 mounted.
Supplied by the PC4504's internal power supply (+5 V, +12 V)
3 V or 5 V
Medium-speed mode* 1 : 4.0 MHz
High-speed mode: 1.0 MHz
Medium-speed mode* 1 : 8.0 MHz
High-speed mode: 2.0 MHz
XC clock: 32 kHz (using the crystal oscillator on the board)
3 V
5 V
3 V / 5 V