Runco CL-610LT - Manual (Page 42)

42 Runco CL-610 Owner’s Operating Manual
On-Screen Display Menus
use different IR codes. Or, you can use a single remote
and change the IR code as needed to address a specific
projector.
When you change the secondary IR code, the remote sends
that code instead of the primary IR code.
NOTE: The Remote Control menu is read-only and need not
be visible in order to change the secondary IR code.
To simultaneously change the secondary IR code and
synchronize that remote with a projector, point the remote at
the projector, then press and hold
◄ and ► simultaneously
for five seconds. The Remote Control edit window, shown
at right, appears. Type a new, two-digit code.
The procedure for changing the secondary IR code on the
remote only is the same, except that you point the remote
away from the projector.
When you replace the projector lamp, you should also reset
the lamp timer. To do this, select
Reset Lamp Timer from
the Set Up menu. Press the right-arrow key on the remote to
highlight “Yes,” then press
Enter to confirm the reset.
NOTE: Reset the Lamp Timer ONLY after you replace
the lamp. Otherwise, the reported “Lamp Hours” will be
inaccurate.
WARNING! Do not exceed the recommended lamp life
of 2000 hours. An old lamp becomes increasingly fragile and
prone to sudden failure.
Select Fan Control from the Set Up Menu to control the
operation of the projector’s cooling fan.
Mode: In most cases, the default Fan Control Mode (Auto
Normal) will maintain the correct operating temperature. If
the lamp frequently turns off due to overheating, or in certain
high-altitude operating environments, you may need to change
this setting to
Auto Hi. Altitude or Manual.
Fan Speed: If you set the Fan Mode to Manual, select Fan
Speed and use the on-screen slidebar to adjust the speed.
After changing either of these settings, press
Exit to return
to the previous menu.
To exit the Set Up menu, use the up- or down-arrow keys to
highlight
Return to User OSD and press Enter.
To return to the Set Up menu, select it from the Main Menu,
press
Enter twice, then press MENU on the remote control.
(You do not need to re-enter the passcode.)
Reset Lamp Timer
Reset only if you
replace lamp
Are you sure?
No Yes
Reset Lamp Timer ➤
Fan Control ➤
Return to User OSD ➤
Fan Control
Mode
Fan Speed
Fan Control
> Auto Normal
Auto Hi. Altitude
Manual
Fan Speed
+2 - +
Remote Control
Secondary +20