RCA UND RECEIVER RTD250 - Manual (Page 20)

EN
17
Advanced Sound Control
Fine Setting of the Speakers
All the basic settings have already been pre-set for the
speakers included in the box.
However, to make the surround sound more effective and
suit the acoustic conditions in your listening room, you may
need to delay the signal coming from some of the speak-
ers. Channel delay compensates for center or surround
speakers that are closer to the listening position than the
front speakers.
You may setup the speakers channel by channel: first, press
the MENU button while in stop mode to enter the setup
menu, then choose Speaker Setup.
To change the speaker size
In the speaker setup menu, press the left or right button to
select a speaker. When the speaker picture is selected, you
may press the up or down button to adjust the speaker
size. The speaker size selection allows you to setup the
device for larger size speakers, such as floor stand speakers.
To change the speaker distance
In the speaker setup menu, press the left or right button to
select a speaker. When the speaker distance column is
selected, you may press the up/down button to adjust the
distance from the front, rear and center speakers individu-
ally.
To change the speaker level
In the speaker setup menu, press the left or right button to
select a speaker. When the speaker level column is selected,
you may press the up/down button to adjust the level of
the front, rear and center speakers individually.
To test the speaker setting
In the speaker setup menu, press the left or right button to
select the "test" column, then press OK to activate. A short
noise will then come from the speakers, one speaker at a
time.
Advanced Setting
Factory Default Setting
The receiver speaker distance default settings are the
following:
Front speakers (L/R) 15 ft
Center speaker (Cch) 15 ft
Rear speaker (SUR) 10 ft
R/S L/S
Rch
Cch
Lch
Front
Left
Rear
Right
Rear
Left
Front
Right
Center
IMPORTANT NOTE
• The speakers provided with this unit are consid-
ered as small speakers. DO NOT select the large
speaker setting as this may shorten the life of the
speakers and affect the unit performance. We rec-
ommend to NOT change the speaker size setting if
you use the speakers included in the box.
• Always use the subwoofer for optimum sound
quality.
SPEAKER SETUP
EXIT
RTD250-EN receiver 10/30/03 10:09 AM Page 21