RCA UND RECEIVER RTD250 - Manual (Page 19)

16
Advanced Sound Control
Stereo
The Stereo mode uses the two main channel outputs from
the front speakers.
Fine Setting of the Components
The receiver can be directly turned on by pressing the
SOURCE Buttons (like DVD/CD, SAT), which also selects the
best surround sound mode. The default surround modes for
different components are as tabled below.
If you decide to change the surround mode, you can press
the AUDIO button repeatedly to toggle among the differ-
ent surround mode choices and select the one you want.
For Digital Signal (2ch PCM), or analog signal , VCR,
Tuner, SAT:
Dolby PL II Movie Dolby PL II Music Dolby PL
Emulation 3 Stereo Arena Jazz Club
Theater Stadium Disco Stereo
For Digital Signal (Dolby Digital)
Dolby Digital 3 Stereo Stereo Dolby PL II
Movie Dolby PLII Music Dolby PL Emulation
For DTS Signal
DTS Stereo
Default Settings
The receiver will keep the last selection in memory as long
as it doesn’t enter standby mode.
Input Signal Setting
The receiver defaults to the most convenient settings for
your easiest use (see table).
Analog Input
Select this setting to play analog signals from VCR or SAT.
DSP (Digital Sound Processor)
These digital sound effects resemble sounds in a real
environment such as Arena, Jazz Club, Theater, Stadium
and Disco. DSP automatically converts analog audio signals
to digital ones which enables you to adjust the sound with-
out degrading the sound quality. Different modes will give
you different feels of size and types of listening environ-
ment. (Not available in Dolby Digital and DTS)
Night Mode
By using Dynamic Range Compression technology, you can
enjoy enhanced Dolby Digital sound quality at night with-
out interrupting your roommates or neighbors. Night Mode
will compress the volume difference between normal voices
and sounds such as explosions, while still enjoying a Dolby
Digital DVD experience. Night Mode can be activated by
pressing the NIGHT button on the remote, DRC SOFT
(Default) will appear on the display. While DRC SOFT
(Default) is still on the display, press the LEFT or RIGHT
adjustment buttons,around the OK button, until you select
the desired mode. There are three modes (OFF, SOFT, SOFT-
ER) for you to choose the extents of compression.
Source/
Source/
If PCM If Analog Input
Input bitstream selected
DVD/CD PRO-LOGIC II N/A
MOVIE
SAT N/A PRO-LOGIC II MOVIE
VCR N/A PRO-LOGIC II MOVIE
TUNER N/A PRO-LOGIC II MUSIC
DEFAULT INPUT (as seen on display)
Analog (SAT/ CAB)
Analog (VCR)
Built-in Tuner
Built-in SOURCE
SAT
VCR
TUNER
DVD/CD
AVAILABLE INPUT
ANL
Built-in
ANL
Built-in SOURCE
SAT
DVD/CD
VCR
TUNER
NOTE
SAT and VCR are just generic names. You can connect
other compatible audio/video components to these
inputs like TV, TAPE, MINI DISC, CD-RW player, etc.
RTD250-EN receiver 10/30/03 10:09 AM Page 20