RIDGID TP1300 - Manual (Page 12)

12
Unpacking and Checking Contents (continued)
The following parts are included:
Item Description Qty
A Thickness Planer ........................... 1
B * Magnetic Knife Handling Tool ........ 1
C * Hex “L” Wrench 4mm .................... 1
D * Open End Wrench 8mm/10mm ..... 1
E
Replacement Blades/Blade Case .. 1
(stored under rear table)
F Operator’s Manual ......................... 1
G Bag of Loose Parts ........................ 1
(Contains the following items)
H Handle............................................ 1
Item Description Qty
J Screw M5 x 0.8-10......................... 1
K Switch Key ..................................... 1
L Upper Leg ...................................... 4
M Lower Leg ...................................... 4
N Long Upper Stiffener...................... 2
P Long Lower Stiffener...................... 2
Q Short Upper Stiffener ..................... 2
R Short Lower Stiffener ..................... 2
S Foot ............................................... 4
T Hardware pack, Legset Hardware . 1
* Supplied in “Tool Box”
Assembling Legset
1. Locate the following parts:
4 Lower Legs
4 Upper Legs
2 Long Upper Stiffeners
2 Short Upper Stiffeners
2 Long Lower Stiffeners
2 Short Lower Stiffeners.
2. From the leg set hardware bag find the
following:
4 Feet
32 Carriage Bolts M8 x 1.25
32 Hex Flanged Nuts M8 x 1.25
NOTE: Hardware not shown actual size.
A
B
C
D
F
G
E
L
M N
P
Q R
S
H J
K
T
Lower Leg
Long Upper
Stiffener
Long Lower
Stiffener
Short Lower
Stiffener
Short Upper
Stiffener
Flange Nut Bolt
Foot
Upper Leg