beautypg.com

Starting/stopping instructions – Ryobi 310r User Manual

Page 10

background image

10

5. SQUEEZE THE THROTTLE TRIGGER TO FULL

THROTTLE. Hold the trigger in this position.

6. PULL THE STARTER ROPE BRISKLY until you hear

the engine sounds like it wants to run (normally 2 to 5
pulls).

7. PLACE THE CHOKE LEVER IN THE "PARTIAL"

POSITION. Pull the starter rope briskly 1 to 3 times to
start the engine. See Fig. 15.

NOTE:

If the engine does not start immediately,
repeat steps 2 through 7.

8. After the engine warms up for 5 to 10 seconds,

PLACE THE CHOKE LEVER IN THE "RUN" POSI-
TION.
See Fig. 15.

STOPPING

To stop the engine, push and hold the stop button until the
engine comes to a complete stop (Fig. 18).

NOTE:

To prevent vapor lock, avoid setting the
unit in the sun.

Fig. 17

STARTING/STOPPING INSTRUCTIONS

Fig. 16

STARTING

1. MIX OIL WITH GAS per instructions (page 8).

2. FULLY PRESS AND RELEASE THE PRIMER BULB

UNTIL FUEL IS VISIBLE IN BULB. See Fig. 14 for
the primer bulb location.

4. HOLD THE BLOWER/VAC IN THE STARTING

POSITION (Fig. 16 for blower, Fig. 17 for vacuum).

3. PLACE THE CHOKE LEVER IN THE FULL "CHOKE"

POSITION. See Fig. 15.

Primer

Bulb

Fig. 14

Fig. 15

Fig. 18