Settings you can change with user tools, For how to enter the user tools program, press the, Fusing temperature 1–normal(+01) – Ricoh FW770 User Manual

Page 52: Default: 2, Fusing temperature 2–high (+02), Mode 5, 1: mode 6, 2: mode 7, 3: mode 8, Default: 0, Fusing temperature 3–low(+03), Mode 2, 1: mode 3, 2: mode 4, 3: mode 5, Default: 1

Copy Settings

Settings You Can Change with User Tools

This section is for the key operators in charge of this machine. You can change
or set the machine's default settings.

Note

❒ For how to enter the User Tools program, press the

{Clear Modes/Energy Saver}

key, and then press the

{Clear/Stop} key for more than 3 seconds.

• Fusing Temperature 1–Normal(+01): Selects the fusing temperature for plain

paper.

Note

❒ 0: Mode 1, 1: Mode 2, 2: Mode 3, 3: Mode 4, 4: Mode 5, 5: Mode 6, 6: Mode 7
❒ Default: 2
❒ For details about each mode, contact your service representative.

• Fusing Temperature 2–High (+02): Selects the fusing temperature for trans-

lucent paper.

Note

❒ 0: Mode 5, 1: Mode 6, 2: Mode 7, 3: Mode 8
❒ Default: 0
❒ For details about each mode, contact your service representative.

• Fusing Temperature 3–Low(+03): Selects the fusing temperature for translu-

cent film.

Note

❒ 0: Mode 2, 1: Mode 3, 2: Mode 4, 3: Mode 5
❒ Default: 1
❒ For details about each mode, contact your service representative.

• Count Up/Down(+04): The copy counter can be made to count up or count

down.

Note

❒ 0: Count up, 1: Count down