RIDGID EB44241 - Manual (Page 11)

11
LOOSE PARTS
UNPACKING
This product requires assembly.

Carefully lift sander from the carton by the base, and
place it on a level work surface.
NOTE: This tool is heavy. To avoid back injury, lift with
your legs, not your back, and get help when needed.
 Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
 Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the tool.
 If any parts are damaged or missing, please call
1-866-539-1710 for assistance.
ASSEMBLY
WARNING:
If any parts are missing, do not operate this tool
until the missing parts are replaced. Failure to do so
could result in possible serious personal injury.
WARNING:
Do not attempt to modify this tool or create acces-
sories not recommended for use with this tool. Any
such alteration or modification is misuse and could
result in a hazardous condition leading to possible
serious personal injury.
throat Plates
rubber feet
knob
hex keys
table insert
sandinG belt
assembly
1-3/4 in. o.d.
washer switCh key
sandinG sleeves
sandinG drums
7/8 in. o.d.
washer
5/8 in. o.d.
washer
2 in. 1-1/2 in. 1 in. 3/4 in. 1/2 in.
Fig. 4
The following items are included with your tool:

Oscillating Edge Belt/Spindle Sander (1)
 Throat Plates (4)
 Switch Key
 Hex Keys ()
 Knob
 Rubber Feet (4)
 Flat Washers (4),1-3/4 in. O.D., 7/8 in. O.D.,
5/8 in. O.D., 1/ in. I.D.
 Sanding Sleeves (5)
 Sanding Drums (4)
 Sanding Belt Assembly
 Table Insert
 Operator's Manual
WARNING:
The use of attachments or accessories not listed might be hazardous and could cause serious
personal injury.
1/2 in. i.d.
washer