Radio Shack TAD-1028 - Manual (Page 12)

12
PREPARATION
SETTING THE DIALING
MODE
Set TONE/PULSE on the handset for the
type of service you have. If you are not
sure which type you have, do this test.
1. Set TONE/PULSE to TONE .
2. Lift the handset and listen for a dial
tone.
3. Press any number other than 0.
Note: If your phone system
requires that you dial an access
code (
9 , for example) before you
dial an outside number, do not
press the access code either.
If the dial tone stops, you have
touch-tone service. Leave
TONE/
PULSE set to TONE .
If the dial tone continues, you have
pulse service. Set
TONE/PULSE to
PULSE .
SETTING THE DAY AND
TIME
The answering system records the day
and time of the call with each phone
message. Follow these steps to set the
current day and time.
Notes:
• To avoid having to reset the day
and time if AC power is lost, we
recommend you install a backup
battery before you set the day and
time. See “Installing a Backup Bat-
tery” on Page 6.
• If you do not complete each step
within 8 seconds, the TAD-1028
sounds a three-tone beep and
stops setting the day and time.
Start again at Step 1.
1. Use a straightened paper clip to
hold down CLOCK until the TAD-
1028 beeps. The TAD then
announces, “Sunday.”
Note: If necessary, adjust VOLUME .
Illus. of TONE/PULSE
switch.
Illus. showing CLOCK
switch.
43-788.fm Page 12 Monday, August 16, 1999 8:19 AM