Radio Shack Digital Answering System with Caller ID Deluxe and 2.4 GHz Digital Spread Spectrum Cordless Phone - Manual (Page 17)

17 Telephone Operation
USING BOTH THE HANDSET
AND SPEAKERPHONE
If someone else is using the speakerphone,
press
TALK on the handset to join the con-
versation. If someone else is using the hand-
set, press
SPEAKER on the base to join the
conversation.
During the call, one person can hang up and
let the call continue. Or, both people can
hang up to end the call.
Note: If you hear a high-pitched noise from
the base’s speaker, the handset and the
base are too close together.
USING FLASH
FLASH performs the electronic equivalent of
a switchhook operation for special services,
such as Call Waiting.
For example, if you have Call Waiting, press
FLASH to answer an incoming call without
disconnecting the current call. Press FLASH
again to return to the first call.
Note: If you do not have any special phone
services, pressing
FLASH might disconnect
the current call.
USING REDIAL
To quickly dial any of the last three numbers
dialed, lift the handset and repeatedly press
REDIAL/PAUSE until the desired number ap-
pears on the display, then press TALK .
Notes:
• The redial memory holds up to 32 digits,
so you can redial long-distance as well
as local numbers.
• The redial memory also holds pause
entries (see “Entering a Pause” on
Page 19).
USING TONE SERVICES ON
A PULSE LINE
Some special services, such as bank-by-
phone, require tone signals. If you have
pulse service, you can still use these special
tone services by following these steps.
1. Be sure PULSE-TONE is set to PULSE .
2. Dial the service’s main number. When
the service answers, press
∗∗∗∗
/ TONE /
6 6 6 6
on the handset. Any additional numbers
you dial are sent as tone signals. When
you hang up, the phone automatically
resets to pulse dialing.
PAGING
To page the person who has the handset or
to locate the handset when the phone is not
in use, press
PAGE on the base. The handset
beeps for 15 seconds and the display shows
FW]_d] FW]_d] FW]_d] FW]_d]
. To locate the handset using a contin-
uous beep, press and hold PAGE longer than
2 seconds. The handset beeps for one
minute. Press any key or place the handset
on the base to stop the page sooner.
Note: The phone rings when a call comes in
while you are using the page feature.
USING A HEADSET
You can talk with hands-free convenience
using an optional headset that has a
3 / 32 -inch
(2.5-mm) plug. Contact your local Ra-
dioShack store for a suitable headset.
To connect the headset, open the rubber
cover on the side of the handset, then insert
the headset’s plug into the jack.
Notes:
• Connecting a headset disconnects the
handset’s earpiece and microphone.