On a wall plate or wall – Radio Shack Digital Answering System with Caller ID Deluxe and 2.4 GHz Digital Spread Spectrum Cordless Phone User Manual

Page 11

Installation

6. Plug the adapter into a standard AC out-

let.

7. Route the AC adapter’s cord and the

modular cord through the strain relief
slots on the bracket.

8. Lift the base’s antenna to a vertical posi-

tion.

On a Wall Plate or Wall

Follow these steps to mount the base on a
wall plate.

1. Insert the bracket’s tabs into the base’s

lower set of tab slots. Press the
bracket’s clips, lower them into the clip
slots, then release the clips.

2. Plug one end of the supplied short mod-

ular cord into the

TEL LINE

jack on the

back of the base.

3. Insert the supplied AC adapter’s barrel

plug into the

DC IN 9V

jack.

4. Route the AC adapter’s cord through

one of the bracket’s grooves. Plug the
modular cord’s other end into the wall
plate jack, then align the base’s keyhole
slots with the wall plate studs and slide
the base downward to secure it.

5. Plug the adapter into a standard AC out-

let.

6. Press and slide up the handset holder to

remove it, turn it over so the tab points
up, then insert it with the arrow pointing
downward until it snaps into place. The
tab at the top holds the handset on the
wall-mounted base.

7. Lift the base’s antenna to an upright

(vertical) position.

To mount the base directly on a wall, follow
the steps under “On a Wall Plate or Wall,”
and follow these additional steps.

Note: You need two screws (not supplied)
with heads that fit into the keyhole slots on
the bottom of the base.

1. Drill two holes 3

inches (100 mm)

apart. Then thread a screw into each
hole, letting the heads extend about

inch (3 mm) from the wall.

2. Plug one end of the supplied long modu-

lar cord into the

TEL

LINE

jack on the

back of the base.

3. Route the AC adapter’s cord and the

long modular cord through the bracket’s
grooves.

4. Plug the modular cord’s other end into a

modular phone jack, then align the
base’s keyhole slots with the mounting
screws and slide the base downward to
secure it.

AC Adapter’s Cord

Short Modular Cord

Studs

Mounting Screws
in Wall