Radio Shack 900 MHz Digital Spread Spectrum Cordless Phone with Digital Answerer and Caller ID/Call Waiting Deluxe - Manual (Page 29)

29 Answering System Operation
Note: If the selected mail box contains new
(unplayed) messages, the TAD announces
“Please play back all messages” and does
not delete any message.
Setting the TAD to Answer Calls
At the command prompt, press # , 6 . The TAD
announces the current outgoing message,
and sets itself to answer the next call.
Setting the TAD Not to Answer
Calls
At the command prompt, press # , 9 . The TAD
announces “Answer off.”
Recording a Memo
1. At the command prompt, press # , 7 . The
TAD announces “Please select mail
box.”
2. Press # and the mail box number. The
TAD announces “Record your message
after the tone.”
3. When you hear the beep, start speaking
your memo.
Note: If the TAD’s memory is full, the
TAD announces “No remaining time”
and returns to the command prompt.
4. When finished, press # , 5 or # , 7 .
Note: The length of the memo recorded by
remote operation must be over 2 seconds
and within 4 minutes.
Recording a New Outgoing
Message
At the command prompt, press # , 8 . The TAD
announces “Record your outgoing message
after the tone.” When you hear the beep,
start speaking your new outgoing message
(up to 30 seconds long). When you finish,
press
# , 5 or # , 8 . The TAD plays back the
new outgoing message.
Listening to the Help Guide
At the command prompt, press # , 0 .