Radio Shack 900 MHz Digital Spread Spectrum Cordless Phone with Digital Answerer and Caller ID/Call Waiting Deluxe - Manual (Page 13)

13 Installation
Follow these steps to turn Auto Talk on or
off.
1. Lift the handset and press MENU . The
Caller ID setup menu appears with
7kje 7kje 7kje 7kje
JWba JWba JWba JWba
selected.
2. Press SELECT to change the auto talk
setting.
Ed Ed Ed Ed
or
E\\ E\\ E\\ E\\
appears indicating the
selected setting.
3. To clear the display when you finish,
press MENU or return the handset to the
base.
TURNING CALLER ID/CALL
WAITING ON/OFF
If you have Call Waiting and Caller ID ser-
vice, you can set the TAD to show Caller ID
information for an incoming call even while
you are on the phone.
Follow these steps to set the Caller ID/Call
Waiting feature.
1. Lift the handset and press MENU .
2. Press 2 or VOL/CID
9 9 9 9
to select
9?:9M 9?:9M 9?:9M 9?:9M
(Caller ID/Call Waiting).
3. Press SELECT to change the Caller ID/
Call Waiting setting.
Ed Ed Ed Ed
,
E\\ E\\ E\\ E\\
, or
Efj Efj Efj Efj
appears.
Note: With the
Efj Efj Efj Efj
setting, you can use the
advanced Caller ID/Call Waiting options. See
“Call Waiting Options Service” on Page 19.
4. Return the handset to the base to store
the new setting.
STORING YOUR AREA
CODE
You can store your local area code in the
phone’s Caller ID record so it does not show
the area code if the received call is from your
local area. If for some reason you need to
dial the area code (or store it in the memory),
you can add it afterwards. See “Adding/De-
leting the Area Code” on Page 21.
Note: If your calling area requires 10-digit di-
aling including area code, do not enter the
area code. Leave this option blank.
Follow these steps to store your area code.
1. Lift the handset and press MENU .
2. Press 3 or VOL/CID
9 9 9 9
twice to select
7h[W 7h[W 7h[W 7h[W 9eZ[ 9eZ[ 9eZ[ 9eZ[
.
3. Press SELECT , then enter your three-
digit area code. If you make a mistake,
repeatedly press
REDIAL/
6 6 6 6
or FLASH/
7# 7# 7# 7#
to move the cursor over the incor-
rect digit, then enter the correct number.
Note: If an area code is already stored,
it appears on the display. To delete the
area code, press
DELETE/CH three
times, then enter your area code. Or you
can use
REDIAL/
6 6 6 6
or FLASH/
7 7 7 7
to
move the cursor and edit the area code.
4. Press SELECT to store the area code,
then press MENU or return the handset
to the base to clear the display.