Radio Shack ET-598 - Manual (Page 25)

25
If you still have problems, disconnect the phone. If other phones on the same line
work properly, the fault is in this phone or its installation. If you cannot find the prob-
lem, take your phone to your local RadioShack store for assistance.
Handset does not ring or
receive a page. • Lift the base’s antenna to a fully vertical
position.
• Move the handset closer to the base.
• Move the handset and base away from
other electrical devices.
• Return the handset to the base to recharge
the battery pack.
The handset stops working or
works poorly during a call. • Fully extend the base’s antenna, and place
it in a vertical position.
• Move the handset closer to the base.
• Be sure the handset’s battery pack is
charged. (If the battery power is too low, it
does not have enough power to light the
BATT LOW indicator.)
• If the base loses power while the handset
is off of it, the security access-protection
code might change. Restore power to the
base, then place the handset back on the
base and leave it there for a few seconds.
The call is too noisy. Change channels, or hang up and redial the
number.
Problem Suggestion
43-698a.fm Page 25 Friday, August 13, 1999 12:56 PM