Connecting and charging the battery pack – Radio Shack ET-598 User Manual

Page 12

Text mode
Original mode

8. Press and lift out the handset

holder, rotate it 180°, then snap it
back into place so it holds the
handset.

9. Raise the base’s antenna to a ver-

tical position and fully extend it.

CONNECTING AND
CHARGING THE
BATTERY PACK

The ET-598 comes with a recharge-
able nickel-cadmium battery pack in-
stalled in the handset. Before using
your phone, you must connect the bat-
tery pack, then charge it for about 14
hours.

1. Remove the screw from the bat-

tery compartment cover on the
bottom of the handset, then press
down and slide off the handset’s
cover.

2. Plug the battery pack’s plastic

connector into the phone’s socket.
The connector fits only one way.

3. Replace the cover and tighten the

screw.

43-698a.fm Page 12 Friday, August 13, 1999 12:56 PM