Radio Shack ET-598 - Manual (Page 10)

10
7. Raise the base’s antenna to a ver-
tical position and fully extend it.
Mounting the Base
Directly on the Wall
To mount the base directly on the wall,
you need two wood screws (not sup-
plied) with heads that fit into the key-
hole slots on the bottom of the base.
1. Drill two holes 3 15 /
16
inches apart. Then
thread a screw into
each hole, letting the
heads extend about
5 /
16
inch from the wall.
5 /
16
3 15 /
16
2. If you have a single 2-line modular
jack, plug one end of the supplied
modular cord into the
TEL LINE 1/2
jack.
Note: When you make this con-
nection, you should not connect
another modular cord to the
TEL
LINE 2 jack or phone operation will
be erratic.
If you have two separate 1-line
modular jacks, plug one end of the
supplied modular cord into the
TEL LINE 1/2 jack and plug an-
other modular cord (not supplied)
into the
TEL LINE 2 jack.
If you have only a single 1-line
modular jack, plug one end of the
supplied modular cord into the
TEL LINE 1/2 jack to use line 1, or
into the TEL LINE 2 jack to use
line 2.
43-698a.fm Page 10 Friday, August 13, 1999 12:56 PM