RCA VR706HF - Manual (Page 59)

Chapter 5 57
Other Information
Finding the TV’s Video Line Input
You need to tune your TV to the video line input if you are using the
VCR’s Audio/Video (A/V) OUT jacks to connect to the TV’s A/V input
jacks. You must select the TV’s video line input before you can see the
VCR’s menus, the cable/antenna reception, and the content that’s on a
tape.
The video line input for TVs varies by brand and model. Below are some
steps to try to find your TV’s video line input:
• If your TV brand is RCA, GE, or Proscan, press the TV button on the
VCR’s remote control, then press the INPUT button.
• If you have another brand of TV, see the chapter Using the Remote
Control to see if the VCR’s remote can be programmed to control your
TV. If so, once completed, follow the step above.
If those options do not work, try the following ideas. You might access the
video line input by:
• Pressing a button on the TV’s remote control (see the table below).
• Selecting a specific channel from the TV’s on-screen menu system (see
the table below).
• Tuning directly to the video line input by selecting a specific channel
number (see the table below)
• Going through all available channels by pressing the channel up or
down buttons on the TV or its remote control.
Common Video Line Input scenarios:
INP
UT
TV
•VCR
ON•OFF
PLAY FORWARD
RECORD STOP PAUSE
F.ADV
CLEAR MENU SPEED
TRACKING
1
4
7
2
5
8
3
6
9
0
CHAN
V
O
L
V
O
L
CHAN
INFO SEARCH
MUTE GO BACK
TV VCR
REVERSE
INPUT
Button
TV Button
Video Input Channel Variations
Button/Switch Button on the Channel
on the TV TV Remote Number
VIDEO VID 1 00
SIGNAL LINE 90
VID 1 VID 91
VID 2 VIDEO 92
S-VID S-VID 93
S-VIDEO INPUT VID 1
S-VIDEO VID 2
SOURCE
AUX