Radio Shack Digital Spread Spectrum Cordless Telephone with Digital Answering System - Manual (Page 15)

15 Operation
MEMORY DIALING
The phone can store up to 10 numbers that
you can dial by entering a memory location
number (0–9).
Storing a Number in Memory
Note: An error tone sounds and the phone
exits the storing process if you wait more
than 20 seconds between each key press.
1. Lift the handset and press MEM . The
TALK/BATT indicator blinks.
2. Enter the number and any tone mode
changes or pause entries (see “Entering
a Pause”).
Notes:
• Each number you store can be up to
20 digits long.
• If you try to enter more than 20 digits,
the phone beeps several times and
exits the storing process. Start over
from Step 2.
• Each tone or pause entry uses one
digit of memory.
3. Press MEM , then enter the memory loca-
tion number ( 0 – 9 ). The handset sounds
a long beep to indicate that the number
is stored.
4. For each stored number,
write the person’s or
company’s name next to
the appropriate location
number on the supplied
memory directory sticker.
Peel the backing off the
sticker and attach it to
the phone.
To replace a stored number, simply store a
new one in its place.
To delete a stored number, lift the handset
and press
MEM twice, then enter the memory
location number (0–9) you want to clear. The
handset sounds a long beep to signal that
the memory location is clear.
Entering a Pause
In some telephone systems, you must dial an
access code (9, for example) and wait for a
second dial tone before you can dial an out-
side number. You can store the access code
with the phone number. However, you
should also store a pause after the access
code to allow the outside line time to con-
nect. To enter a 2-second pause, press
PAUSE . For a longer pause, press PAUSE ad-
ditional times.
Dialing a Memory Number
To dial a number stored in a standard memo-
ry location, press
TALK . When you hear a
dial tone, press MEM and enter the memory
location number for the number you want to
dial.
Note: If you select an invalid or empty mem-
ory location, the phone sounds an error tone.
Press
MEM and enter the memory location
number again.
Chain-Dialing Service Numbers
For quick recall of numbers for special ser-
vices (such as alternate long distance or
bank-by-phone), store each group of num-
bers in its own memory location.
Dial the service’s main number first. Then, at
the appropriate place in the call, press
MEM
and enter the memory location number (0–9)
for the stored information.
43-3805.fm Page 15 Wednesday, May 17, 2000 3:48 PM