Rhino Mounts SE42 - Manual (Page 127)

MAINTENANCE
SE42 03/08 Maintenance Section 5-3
© 2008 Alamo Group Inc.
MAINTENANCE
Gearbox Lubrication
The gearbox should be full (18 ounces).54 liters
and not require additional lubricant unless the box
is cracked or a seal is leaking. It is recommended
that the 1/8” oil level plug (Mnt-R-0009) be removed
after every 10 hours of operation. If required, oil
should be added until it runs out hole.
Recommended lubricant is NLGI 000 Grease,
Alamo Group P/N 00765444. The gearbox capacity
is one quart.
NOTE: Make sure mower is level when checking oil in the gearbox.
NOTE: Overfilling of Gearbox will cause pressure to build up and cause Grease Seals to leak.
Driveline Lubrication
Grease Fittings are located on the Cross Assembly
of each U-Joint and on the telescoping tubes.
Grease the U-Joint after each 8 hours of use. Mnt-
0024. Do not force grease through the Needle Cup
Assemblies. Grease the telescoping tubes after
every 8 hours use. To grease profile tube,
disconnect drive from PTO and pull halves apart.
Pump grease into outer profile tube and reinstall
together. Lubricate the shield bearings every 8
hours.