Roberts Radio 105 - Manual (Page 64)

63
Information
Factory reset
If you wish to completely reset your radio to its initial state this may be
performed by following this procedure. By performing a factory reset, all
user entered settings will be erased.
1. Access the menu for the current mode by pressing the Menu button.
Rotate the Tuning/Select control to highlight the 'Main menu' option,
then press the control to select.
2. Rotate the Tuning/Select control until 'System settings' is highlighted
and then press the control to select.
3. Rotate the Tuning/Select control until 'Factory Reset' is highlighted
and then press the control. Rotate the Tuning/Select control and
highlight 'YES' to proceed.
If you do not wish to carry out a system reset, highlight 'NO' and then
press the control. The display will revert to the previous menu.
4. With 'YES' highlighted, press the Tuning/Select control. The radio
will restart as if fi rst plugged in and a full reset will be performed. The
preset stations will be erased and your wireless network connection
details will be lost. All confi guration settings will be restored to their
defaults, the clock and alarms will be reset. The radio will then launch
the 'Setup wizard'. If you wish to leave the radio in a reset condition,
switch off the radio at this point.
In case of malfunction for any reason, reset the product as described
above to resume normal operation. It may be necessary in some cases
to disconnect the mains power and remove batteries, then reconnect
power after 10 seconds.
In case of malfunction due to electrical fast transient (burst), reset the
product as above (reconnection of the power source may be required) to
resume normal operation.
1
1-4