Roberts Radio 105 - Manual (Page 60)

59
Display and Audio
Brightness control
The brightness of the display can be adjusted for when the radio is in
Standby and for when it is in use. If you use the unit in the bedroom, you
may prefer a lower standby brightness level than the standard setting.
There are three brightness levels and an almost off 'night-time' setting.
1. Press the On/Off button to switch on your radio. Access the menu for
the current mode by pressing the Menu button.
2. Rotate the Tuning/Select control until 'System settings' is highlighted
on the display. Press the control to enter the system settings menu.
Rotate the Tuning/Select control until 'Brightness' is highlighted on
the display. Press the control.
3. To adjust the display brightness when the radio is switched on rotate the
Tuning/Select control until 'Normal' is highlighted on the display.
To adjust the display brightness when the radio is in standby rotate
the Tuning/Select control until 'Standby' is highlighted.
Press the control to enter the selected brightness adjustment mode.
4. To adjust the brightness level rotate the Tuning/Select control clockwise
to increase the brightness level and anti-clockwise to decrease it.
The backlight level will change as the control is rotated so that you
can see the effect of each setting. Note that the backlight is almost
completely off at the zero setting. Press the control to set the level.
Press the Menu/Back button to exit.
When the radio is in Standby mode, pressing a button or turning the rotary
control will cause the radio to switch to the Normal brightness level for a
few seconds. This is so that even if the Standby brightness level is set
to zero, it is still possible to see the time by quickly pressing a button.
1
1,4
2-4