Ryobi 180r - Manual (Page 4)

SAFETY WARNINGS
4
• A nameplate on your unit indicates what
voltage it uses. Never connect the unit to an
AC voltage that differs from this voltage.
• Inspect all extension cords and the unit
power connection periodically. Look closely
for deterioration, cuts or cracks in the
insulation. Also inspect the connections for
damage. Replace the cords if any defects
or damage appear.
• Avoid dangerous environments. Never
operate your unit in damp or wet conditions.
Moisture is a shock hazard.
• Do not use the unit in the rain.
• Do not handle the plug or Blower/Vacuum
with wet hands or standing on any
wet surfaces.
BEFORE OPERATING
• Read the instructions carefully. Be familiar
with the controls and proper use of the unit.
• Children and adolescents must not
manipulate units, except for adolescents
in training and under the supervision of
a specialist.
• Before each use, thoroughly inspect your
Blower/Vacuum for loose or damaged parts.
Do not use until adjustments or repairs are
made.
• All guards and safety attachments must be
installed properly before operating the unit.
• Use the unit only in daylight or good artificial
light.
• Keep all bystanders, especially children and
pets, at least 30 feet (9.2 m) away from the
unit during operation.
• Inspect the area before starting the Blower/
Vacuum. Remove all debris and hard or
sharp objects such as glass, wire, etc.
FOR SAFE OPERATION
• Do not leave the Blower/Vacuum plugged in
when not in use, changing attachments, or
while being serviced.
• Do not allow this product to be used as
a toy.
• Use the right tool. Do not use unit for for any
job except that for which it is intended. Use
only the manufacturer’s recommended
attachments.
• Avoid accidental starting. Do not carry
plugged-in unit with your finger on
the switch. Be sure switch is off when
plugging in.
• Do not abuse the power cord. Never carry
the unit by the cord or yank the plug out of
the receptacle. Keep the cord away from
heat, oil and sharp edges.
• Do not unplug by pulling on the cord. To
unplug, grasp the plug, not the cord.
• Always remain alert. Use common sense. To
prevent injury to yourself and others, do not
operate this unit if you are fatigued.
• Do not operate the unit while under the
influence of drugs, alcohol or medication.
• Wear goggles or safety glasses at all times
when operating this Blower/Vacuum.
• Use a face mask or dust mask if operation
is dusty.
• Do not overreach or use the unit from
unstable surfaces such as ladders, trees,
steep slopes, rooftops, etc. Keep proper
footing and balance at all times.
• Dress properly. Do not operate this
Blower/Vacuum when barefoot or wearing
open sandals. Always wear sturdy,
rubber-soled footwear. The use of gloves,
ear/hearing protection and long pants
are recommended.
MINIMUM WIRE SIZE FOR EXTENSION CORDS
FOR 120 VOLT APPLIANCES
Cord length (ft) 25 50 100 150
Amperage Rating Wire size (AWG)
6 to 10 amps 18 16 14 12
10 to 12 amps 16 16 14 12
12 to 16 amps 14 12
NOT
RECOMMENDED
• CORD SETS: Make sure your cord set is in
good condition. When using a cord set, be
sure to use a cord that is heavy enough to
carry the current that your unit will draw.
An undersized cord set will cause a drop in
line voltage resulting in loss of power and
overheating. The table shows the correct size
to use depending on the cord length and
nameplate amperage rating. If in doubt, use
the next heavier size line gauge. The smaller
the gauge number, the heavier the cord. To
reduce the possibility of disconnection of the
unit from the cord set during operation, see
Fig. 14, page 10.