Radio Shack TAD-725 User Manual

Page 28

If you still have problems, disconnect the TAD-725. If other phones on the same line
work properly, the fault is in this phone or its installation. If you cannot find the prob-
lem, take your phone to your local RadioShack store for assistance.

The handset does not ring or
receive a page.

Move the base away from other electrical
devices and sources of noise.

The handset stops working or
works poorly during a call.

Move the handset closer to the base.

Lift the base’s antenna to a vertical position.

Be sure the battery pack is charged. (If the bat-
tery power is too low, it does not have enough
power to light the display.)

If the base loses power while the handset is
away, the security access-protection code might
change. Restore power to the base, then place
the handset back on the base. The CHARGE/IN
USE indicator lights, indicating that the code is
set again.

Check the charging contacts on the handset and
base. If they are dirty, clean them with a pencil
eraser.

The TAD does not answer
calls.

Make sure the TAD is turned on.

Make sure the AC adapter is properly con-
nected.

Check all phone line connections.

The TAD does not record call-
ers’ messages.

REC TIME

is set to

ANN

(announcement only).

Set it to

Delete messages if memory is full.

The TALK/BATT indicator
flashes slowly when it is on the
base and/or the CHARGE/IN
USE indicator flashes every few
seconds.

Be sure the battery pack is correctly connected.

Problem

Suggestion

43-725.fm Page 28 Tuesday, February 23, 1999 2:47 PM