Radio Shack TAD-725 - Manual (Page 24)

24
To replay the current message from the
beginning, press
REPEAT . If you press
REPEAT within about 4 seconds after a
message begins playing, the TAD re-
plays the previous message.
ADJUSTING THE TAD’S
VOLUME
To adjust the speaker’s volume, repeat-
edly press
VOLUME or on the
base. The volume setting from 1 (low-
est) to 10 (highest) appears in the mes-
sage counter window.
DELETING MESSAGES
To delete the current message while it is
playing, hold down
DELETE until the
TAD beeps.
To delete all messages at once, while
messages are not playing, hold down
DELETE on the base until the TAD
beeps and 0 appears in the message
counter window.
Note: You cannot delete new (un-
played) messages. If you try to delete all
messages at once while you still have
new messages, the TAD sounds five
quick beeps and does not delete any
messages.
SETTING THE REMOTE
OPERATION PIN
The TAD-725’s two-digit remote opera-
tion PIN (personal identification number)
prevents unauthorized remote access to
your messages. The PIN is preset to 80.
Follow these steps to change the PIN to
any number from 00 to 99.
Note: If you wait more than 2 minutes
between each keypress, the TAD exits
the PIN setting process. Start again at
Step 1.
1. Hold down PIN until the TAD beeps
and 00 appears in the message
counter window.
2. Press SKIP to set the first digit of the
PIN higher or REPEAT to set it lower.
Then press PIN .
3. Press SKIP or REPEAT to set the
second digit of the PIN, then press
PIN . The TAD announces the new
PIN.
To check your PIN at any time, press
PIN . The PIN appears in the message
counter window, and the TAD announc-
es it.
Note: If the TAD loses power for longer
than about one hour, the PIN resets to
80.
REPEAT
REPEAT PIN SKIP
43-725.fm Page 24 Tuesday, February 23, 1999 2:47 PM