Radio Shack TAD-725 - Manual (Page 12)

12
1. Set DIAL MODE to T (tone).
2. Lift the handset and listen for a dial
tone.
Press any number other than 0 .
Note: If your phone system requires
that you dial an access code (9, for
example) before you dial an outside
number, do not press the access
code number either.
If the dial tone stops, you have
touch-tone service. Leave
DIAL
MODE set to T .
If the dial tone continues, you have
pulse service. Set
DIAL MODE to P
(pulse).
3. Press TALK or place the handset on
the base to hang up.
TURNING THE BASE’S
RINGER ON AND OFF
To turn off the base’s ringer, set RINGER
on the back of the base to OFF . You can
still make or receive calls using this
phone. Telephones on the same line
and the TAD’s handset still ring when
there is an incoming call.
Note: When the base’s ringer is turned
off and the handset is in its cradle, the
phone does not ring. If the handset is
not in the cradle, the phone rings.
To turn on the base’s ringer, set RINGER
to ON .
SETTING THE RINGER
TONE/VOLUME
You can select one of four different ring-
er tone/volume settings while the phone
is not in the talk mode.
Press VOLUME to advance to the next
ringer level setting.
VOLUME
43-725.fm Page 12 Tuesday, February 23, 1999 2:47 PM