Radio Shack PRO-2056 - Manual (Page 21)

21
STORING FREQUENCIES
INTO CHANNELS
1. When the scanner displays a fre-
quency you want to store while
scanning the banks or searching
the search bands, press
PROG .
CH flashes, and HOLD and the fre-
quency number appear.
2. Press PRIVATE , POLICE , or FIRE/
EMG to store the frequency into a
channel. For example, if you want
to store the frequency in one of
the channels in the POLICE ser-
vice search bank, press
POLICE .
If the search bank you selected
has an empty channel, the fre-
quency number flashes alternately
with the lowest empty channel
number and
000.0000 . If the
search bank you selected has no
empty channels, the frequency
number flashes alternately with
the channel number of the last
channel where you stored a fre-
quency.
Note: If you press a service
search bank key other than
PRI-
VATE , POLICE , or FIRE/EMG , the
scanner beeps several times and
Error appears. If you are scan-
ning the banks, press PRIVATE ,
POLICE , or FIRE/EMG , then start
again from Step 1. If you are
searching the search bands,
press SEARCH then start again
from Step 1.
3. Press PROG to store the fre-
quency in the displayed channel.
Or, repeatedly press s or t, select
a channel number, then press
PROG . The scanner displays the
channel number where you stored
the frequency.
Note: If you select a channel with
a frequency already stored in it,
the scanner replaces the fre-
quency with the new one.
To cancel storing the frequency,
press
BAND .
4. Repeat Steps 1 – 3 to store more
frequencies into channels.
5. When you finish storing frequen-
cies, set MEMOLOCK OFF/ON to
ON to prevent accidentally chang-
ing them (see “Using Memolock”
on Page 23).
20-147.fm Page 21 Tuesday, August 3, 1999 3:23 PM